Knowledgebase: Software Setup
Extra circles in my tool path in Mach3.
Posted by on 13 June 2017 08:08 AM

If you load a G code  file into mach3 and there are extra circles in the tool path that where not part of the program you are in absolute IJ rather the in incremental IJ mode. You can correct that two ways, first is in Mach3 click on the Config>General config tabs and change it in the IJ mode box. (see attachement) the second way to address the issue is to add a G91.1 in the begining of the G code file.

(0 vote(s))
Not helpful

Comments (0)
Post a new comment
Full Name: