Greetings!
I'm an OLD (76yrs) hobbyist, and have been using Mach 3 for several years with imperial as native units. As the world turns, so have I and it's time to convert to metric! My system is Windows 10, 64bit. My drawings are 3D done in Blender 4.3, and I use CamBam 1.0 set to mm for the doing CAM issues. My system is wired to a Sherline 2000 Mill and a Sherline 4400 Lathe.
So far, I changed the native units to mm. I re-calibrated the motors (motor tuning), and set the steps per, in the Settings (Alt 5) tab. The soft limits have also been reset.
Now, my only problem is, the measured settings drawn are not correct when I try machining!!! After a week of trial and error, I'm here for help!
Greetings!
I'm an OLD (76yrs) hobbyist, and have been using Mach 3 for several years with imperial as native units. As the world turns, so have I and it's time to convert to metric! My system is Windows 10, 64bit. My drawings are 3D done in Blender 4.3, and I use CamBam 1.0 set to mm for the doing CAM issues. My system is wired to a Sherline 2000 Mill and a Sherline 4400 Lathe.
So far, I changed the native units to mm. I re-calibrated the motors (motor tuning), and set the steps per, in the Settings (Alt 5) tab. The soft limits have also been reset.
Now, my only problem is, the measured settings drawn are not correct when I try machining!!! After a week of trial and error, I'm here for help!
Any and all suggestions GREATLY appreciated!