Need a little assistance with Gear Setup and the M Codes (40-45). I have a variable speed mill with 6 gears (1-3 H/L) (40-3000 rpm). I found the configuration page but not sure how to incorporate the usage within the G Code files. If I insert a gear change command will Mach4 stop and wait for the change to occur or is there a stop command that is required? Will Mach4 display what Gear/Pully is required based on the speed requirement of the tool selection?
Need a little assistance with Gear Setup and the M Codes (40-45). I have a variable speed mill with 6 gears (1-3 H/L) (40-3000 rpm). I found the configuration page but not sure how to incorporate the usage within the G Code files. If I insert a gear change command will Mach4 stop and wait for the change to occur or is there a stop command that is required? Will Mach4 display what Gear/Pully is required based on the speed requirement of the tool selection?
Your assistance is greatly appreciated!