I have the Pokeys57cnc installed and running. I am trying to set soft limits and limit switches. Yesterday when I left for the day the jogging was working with a few problems of which I will detail. When I press the left arrow the Z axis moves about an inch left and stops. The right arrow moves it to the right and trips the limit switch and I have to turn off the program and manually move the X axis off the limit switch and restart the program. When I press the up arrow this is where it is really strange as the Y axis moves toward the Y home and the slave axis never moves but the Z axis moves down. When I press the down arrow the reverse happens. the Y axis moves away from home and the Z axis goes up. When I press the PgUp button the Y slave moves toward the home position of Y. The PgDn button moves the Y slave away from the home position. I have looked for ways to fix this with no luck. I'm pretty sure it is something in the settings but I don't know where to find it. If you could point me in the right direction it would be greatly appreciated as I would really like to use my machine.to make some cuts. If you do a TeamViewer I have that installed on my computer and would give you access. Thanks and hope to hear from you soon.
I have the Pokeys57cnc installed and running. I am trying to set soft limits and limit switches. Yesterday when I left for the day the jogging was working with a few problems of which I will detail. When I press the left arrow the Z axis moves about an inch left and stops. The right arrow moves it to the right and trips the limit switch and I have to turn off the program and manually move the X axis off the limit switch and restart the program. When I press the up arrow this is where it is really strange as the Y axis moves toward the Y home and the slave axis never moves but the Z axis moves down. When I press the down arrow the reverse happens. the Y axis moves away from home and the Z axis goes up. When I press the PgUp button the Y slave moves toward the home position of Y. The PgDn button moves the Y slave away from the home position. I have looked for ways to fix this with no luck. I'm pretty sure it is something in the settings but I don't know where to find it. If you could point me in the right direction it would be greatly appreciated as I would really like to use my machine.to make some cuts. If you do a TeamViewer I have that installed on my computer and would give you access. Thanks and hope to hear from you soon.