Hello,
I have been running the mach 3 program for several months with no problems. Until today.
The only thing that has been different is that the programs I wrote yesterday somehow started getting saved in the Mach 3
program folder. I wrote 4 new programs and again,somehow, they began to save in the Mach 3 program file.
I didn't pay much attention because the software and hardware continued to run normally.
Just 20 minutes ago I tried to bring the software up and I started to receive error messages, and they continue to loop, over
and over until I stopped them with the task manager. I then looked into the program file and there were the 4 new program files, listed with everything else.
I did believe I had found the error that I had made. I took the files out and put them on the desktop.
And so I need to know how to proceed. The errors go in a loop of something/ something.dll was read wrong, ending up witgh and 3 to 4 error prompts later.
Always repeating too error R6034 some critical error has occurred.
So I need your assistance please, we are finally producing with the unit and this error, I cannot fix without assistance.
My brother is Rhet Jensen, and I am lance Jensen, I did the machine purchase, and the software, should be in my name as well.
Please contact me as soon as possible.
Thanks ,
Lance Jensen
801-318-8806
Hello,
I have been running the mach 3 program for several months with no problems. Until today.
The only thing that has been different is that the programs I wrote yesterday somehow started getting saved in the Mach 3
program folder. I wrote 4 new programs and again,somehow, they began to save in the Mach 3 program file.
I didn't pay much attention because the software and hardware continued to run normally.
Just 20 minutes ago I tried to bring the software up and I started to receive error messages, and they continue to loop, over
and over until I stopped them with the task manager. I then looked into the program file and there were the 4 new program files, listed with everything else.
I did believe I had found the error that I had made. I took the files out and put them on the desktop.
And so I need to know how to proceed. The errors go in a loop of something/ something.dll was read wrong, ending up witgh and 3 to 4 error prompts later.
Always repeating too error R6034 some critical error has occurred.
So I need your assistance please, we are finally producing with the unit and this error, I cannot fix without assistance.
My brother is Rhet Jensen, and I am lance Jensen, I did the machine purchase, and the software, should be in my name as well.
Please contact me as soon as possible.
Thanks ,
Lance Jensen
801-318-8806