Knowledgebase: FAQ's
What is an XML?
Posted by Jim Dingus on 26 June 2015 01:59 PM

It is a Mach3 configuration file. Every Mach3 profile stores its settings in an XML file located in the Mach3 installation directory (C:\Mach3 by default). If Mach3 is loaded using the “MyMill” profile, those settings would be stored in MyMill.xml. The name of the currently loaded profile can be seen in the lower-right corner of the Program Run screen in the default screen set. See “What is a profile?”

(1 vote(s))
Helpful
Not helpful

Comments (0)
Post a new comment
 
 
Full Name:
Email:
Comments: